Vulcan 1ER50A User Manual download pdf (Page 26)

ERA, ERAF, ERD, ERDF, ERC, ERCF SERIES ELECTRIC FRYERS

VULCAN-HART F-32959 Rev. E (August 2012)

-26-

OIL OUT PROCEDURE:

Use the Boil Out By-Pass™ drain extension allowing the boil

out solution to exit the fry tank without using the filtering

system. Do not allow water to run through the motor / pump.

Drain the boil out solution into a bucket or place a hose on the

end of the drain extension allowing the other end to flow into a

floor drain. In Fig. 6 the arrow is pointing to the drain

extension. It is threaded into the top coupling of the oil drain

tube. Drain extension needs to be only hand tightened.

Boil Out By-Pass™ Extension Tube

Fig. 6

Standard Hose End Drain Tube End

THERMAL OVERLOAD PROTECTION BUTTON:

The motor/pump supplied with the filtering system

has a thermal overload protection circuit that senses

when excess heat occurs due to filtering for long

periods of time or under heavy load prior to

discarding debris buildup. If the thermal overload

protection is tripped, wait 5 minutes and then reset

the motor by pushing in the red button. The arrow in

Figure 7 shows the location of the reset button;

located on the front of the motor / pump facing

towards you.

Fig. 7

1 2 ... 21 22 23 24 25 26 27

No comments

Vulcan 1ER50A User Manual Page 26