Vulcan 1ER50A User Manual download pdf (Page 9)

ERA & EBD SERIES ELECTRIC FRYERS - REMOVAL AND REPLACEMENT OF PARTS

FILL SOLENOID VALVE

(KLEENSCREEN FRYERS ONLY)

1. Disconnect swivel pipe fitting at rear of fry tank.

2. Disconnect fill solenoid valve lead wire

connector from below control panel.

3. Remove screws (2) securing the solenoid valve

body flange to pipe tee then remove the

assembly from fryer.

A. Remove pipe fittings from solenoid valve

and install on replacement valve.

4. Reverse procedure to install and check for

proper operation.

HEATING ELEMENTS

Do not sharply bend and kink, or clamp

down on the capillary tube or damage may occur.

1. Raise heating elements.

If replacing left heating element, loosen

high limit bulb and capillary tube clamps.

Remove high limit bulb and capillary tube

from clamps then position away from

element.

B. If replacing right

heating element, remove

temperature probe clamps and position

temperature probe away from element.

NOTE: When installing high limit, route the capillary

tube and center the bulb between the clamps before

tightening.

2. Remove element assembly clamps.

3. Remove element head cover as outlined under

COVERS AND PANELS.

4. Disconnect heating element lead wires.

NOTE: Each heating element assembly contains

three individual elements (six lead wire connections

total).

5. Remove screws from heating element mounting

bracket and remove heating element.

F25385 (May 2010)Page 9 of 32

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Vulcan 1ER50A User Manual Page 9