Vulcan VHX7G User Manual download pdf (Page 6)

– 6 –

Fig. 1

LEVELING

Using a spirit level, adjust the leveling feet to level the steamer front-to-back and side-to-side.

Mark hole locations on the floor through the anchoring holes provided in the rear flanged adjustable

feet. Move the steamer and drill holes in the floor at the marked locations. Insert proper anchoring

devices. Set the steamer back in the proper position. Bolt and anchor the leveled steamer securely

to the floor. Seal bolts and flanged feet with Silastic or equivalent compound.

After the drain is connected, check for level by pouring water onto the floor of the compartment.

All water should drain through the opening at the back of the compartment.

SERVICE CONNECTIONS (Fig. 1)

PL-56413

ELECTRICAL CONNECTION

STEAM UNLOADER PORTS

DRAIN

CONDENSING COLD

WATER CONNECTION

GENERATOR WATER

CONNECTION

GAS CONNECTION

UNLESS OTHERWISE SPECIFIED, ELECTRICAL CONNECTION TO BE 120 VOLTS, 60 HERTZ SINGLE PHASE WITH

GROUND. FURNISHED WITH 4 1/2 FOOT CORD WITH 3 PRONG PLUG. MAXIMUM 4.0 AMPS.

DRAIN: 2" IPS PIPED TO OPEN FLOOR DRAIN. NO SOLID CONNECTION. MAXIMUM 24" LENGTH BEFORE

OPEN AIR GAP OPENING. (NO BENDS OR ELBOWS).

GAS CONNECTION: 3/4" IPS SUPPLY LINE REQUIRED.

CONDENSING COLD WATER: 3/8" O.D. TUBING AT 25-50 PSI (170 TO 345 kPa).

GENERATOR WATER: 3/8" O.D. TUBING AT 20 TO 60 PSI (138 TO 413.7 kPa).

SERVICE CONNECTIONS

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

No comments

Vulcan VHX7G User Manual Page 6