Vulcan VSX3E User Manual download pdf (Page 11)

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS

Page 11 of 40

GAS PRESSURE REGULATOR

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

WARNING:

SHUT OFF THE GAS SUPPLY

BEFORE SERVICING THE UNIT.

WARNING:

ALL GAS JOINTS DISTURBED

DURING SERVICING MUST BE CHECKED FOR

LEAKS. CHECK USING A SOAP AND WATER

SOLUTION (BUBBLES). DO NOT USE AN OPEN

FLAME.

A. BEFORE LIGHTING UNIT, CHECK ALL

JOINTS PRIOR TO THE GAS VALVE

(SOLENOID).

B. CHECK ALL JOINTS BEYOND GAS

VALVE (SOLENOID) AFTER THE UNIT

HAS LIT.

1. Remove the right side panel as outlined under

"COVERS AND PANELS".

2. Remove the gas solenoid valve as outline under

“GAS SOLENOID VALVE”.

3. Remove the gas pressure regulator from the

pipe nipple below it.

4. Reverse the procedure to install.

5. Adjust the gas regulator pressure as outlined

under “MANIFOLD PRESSURE

ADJUSTMENT”.

6. Check unit for proper operation.

FLAME SENSE PROBE (GAS)

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

WARNING:

SHUT OFF THE GAS SUPPLY

BEFORE SERVICING THE UNIT.

1. Cut the wire ties around “wire bundle” and trace

the Flame Sense Probe (FSP) wire to an in-line

splice (butt connector) and cut the wire close to

the connector.

2. Remove the screw holding the flame sense

probe onto the mounting bracket and lift out.

3. Reverse the procedure to install a new probe

then check FSP for proper operation as outlined

under “FLAME SENSE PROBE”.

NOTE:

The opposite end of the in-line splice will

have to be cut close to the connector and the wire

insulation stripped back approximately 0.250 inch to

install a new connector.

WATER LEVEL CONTROL

BOARD

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

1. Remove the right side panel as outlined under

"COVERS AND PANELS".

2. Disconnect the lead wires from the water level

control board (WLC).

3. Remove mounting screws.

4. Move board to the left and rotate outwards when

removing, to clear wire bundle.

5. Reverse the procedure to install, then check unit

for proper operation.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Comments to this Manuals

No comments

Vulcan VSX3E User Manual Page 11

Comments to this Manuals

Related products and manuals for Food Steamer Vulcan VSX3E