Vulcan VSX3E User Manual download pdf (Page 14)

VSX SERIES STEAMER - REMOVAL AND REPLACEMENT OF PARTS

Page 14 of 40

(Gas Model Shown)

(Electric Model Shown)

5. Disconnect the steam lines on the top right and

left side of the tank, the water fill tube, the drain

line, then the delime line at the bottom left

corner.

6. Electric Models Only - For gas models proceed

to step 7.

A. Remove the heater lead wires, control and

high limit thermostat bulbs, then remove the

heater from the tank.

B. To remove tank, loosen

the nut on the left

side mounting stud of the tank and remove

the two nuts from the mounting studs on the

right side of the tank.

C. Push the right side of the tank toward the

rear of the unit enough to clear the studs

from the mounting bracket then, pull tank

toward the right to remove.

D. Reverse the procedure to install and check

unit for proper operation.

7. Gas Model Only

A. Remove the burner assembly and place to

the side.

B. Remove the bolts that secure the manifold

to the burner box frame and place to the

side.

C. Remove the surface high limit and the

control thermostat bulb from the tank.

D. Remove the combination Left side and Rear

panel as outlined under “COVERS AND

PANELS”.

8. Remove the nuts and washers from studs on

each side of the tank that secure it to the steam

cavity and lift the steam generator tank out.

9. Reverse procedure to install and check unit for

proper operation.

WATER LEVEL PROBES

WARNING:

DISCONNECT THE ELECTRICAL

POWER TO THE MACHINE AT THE MAIN

CIRCUIT BOX. PLACE A TAG ON THE CIRCUIT

BOX INDICATING THE CIRCUIT IS BEING

SERVICED.

1. Remove the top cover as outlined under

"COVERS AND PANELS".

2. Disconnect the lead wire to water level probes.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments

Vulcan VSX3E User Manual Page 14

Comments to this Manuals

Related products and manuals for Food Steamer Vulcan VSX3E