Vulcan K20GL User Manual Page 1

INSTALLATION & OPERATION MANUAL GAS 2/3 JACKETED STATIONARY AND TILTING KETTLES MODELS K20GL ML-136090 K40GL ML-136091 K60GL

— 10 — GAS KETTLES LOCATION Position the kettle in its final location. Check that there are sufficient clearances for operating and servicing the k

— 11 — GAS KETTLES Tilting Kettle "Q" "P" "E" "F" "M" ADD 2" FOR PLUG VALVE

— 12 — GAS KETTLES the kettle. OPERATION The kettle and its parts are hot. Use care when operating, cleaning or servicing CONTROLS AND INDICAT

— 13 — GAS KETTLES BEFORE OPERATION 1. Check Gauge Pressure – should read 20-30 In. Hg. below zero when cold. (Higher reading indicates air in jack

— 14 — GAS KETTLES VENTING While the kettle is cold, check the vacuum/pressure gauge. The gauge should be in the vacuum zone measuring between 20 t

— 15 — GAS KETTLES STAINLESS STEEL EQUIPMENT CARE AND CLEANING (Supplied courtesy of NAFEM. For more information, visit their web site at www.nafem.

— 16 — GAS KETTLES 4. Treat your water. Though this is not always practical, softening hard water can do much to reduce deposits. There are ce

— 17 — GAS KETTLES CLEANING The kettle and its parts are hot. Use care when operating, cleaning or servicing the kettle. Disconnect the electri

— 18 — GAS KETTLES PLUG VALVE CLEANING INSTRUCTIONS Daily After Use Remove draw-off valve plug for cleaning (Fig. 3). 1. Unscrew the retaining rin

— 19 — GAS KETTLES MAINTENANCE The kettle and its parts are hot. Use care when operating, cleaning or servicing the kettle. VENTING When cold, th

GAS KETTLES — 2 — IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD

GAS KETTLES F-35461 (June 2012) — 20 — PRINTED IN U.S.A. TROUBLESHOOTING Problem Possible Causes / Suggested Corrective Action Will Not Turn On,

GAS KETTLES — 3 — CONTENTS GENERAL ...

GAS KETTLES — 4 — INSTALLATION, OPERATION AND MAINTENANCE OF KGL AND KGLT SERIES GAS KETTLES SAVE THESE INSTRUCTIONS FOR FUTURE USE GENERAL V

GAS KETTLES — 5 — INSTALLATION UNPACKING This kettle was inspected before leaving the factory. The transportation company assumes fu

GAS KETTLES — 6 — GAS CONNECTIONS Gas supply connections and any pipe joint compound must be resistant to the action of propane gases. Codes requ

GAS KETTLES — 7 — Gas Connection Data FLEXIBLE GAS CONNECTORS BTU/hr. FLOW CAPACITY 1, 2 LENGTH 3 LENGTH 3 End Fittings - (1) Quick Disconnect

GAS KETTLES — 8 — GAS AND ALTITUDE CONVERSION The kettle can be field converted to propane gas or for operation at altitudes above 2000ft elevation.

— 9 — GAS KETTLES Altitude: 1. Remove the right side controls compartment side panel. 2. Locate the gas combination valve located in the bottom of