Vulcan K20EL User Manual download pdf (Page 9)

Fig. 14

NOTE: If liquid drained from kettle is still clean, save

for reuse.

5. Remove CONTROL BOX COVER.

6. Note lead wire locations and disconnect wires

from heating element.

7. Remove mounting nuts securing heating element

to kettle.

Fig. 15

8. Remove heating element from kettle.

9. Reverse procedure to install. Use a new heating

element seal whenever installing heating

element. Torque mounting bolts to 40 ft-lbs and

tighten in an alternating pattern.

10. Refill jacket with fluid. See FILLING THE

RESERVOIR JACKET.

11. Remove air from reservoir jacket as outlined

under VENTING.

12. Check for proper operation and leaks around

heating element.

WATER LEVEL PROBE (LLCO)

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Open pressure relief valve until reservoir jacket

is completely vented.

2. Remove BOTTOM COVER.

3. Disconnect lead wires from the water level

probe .

Fig. 16

4. Place a large container under kettle to catch

liquid that drains from kettle.

NOTE: If liquid drained from kettle is still clean, save

for reuse.

5. Remove component from bottom of kettle.

6. Reverse procedure to install.

NOTE: Clean threads and apply pipe thread sealant

when replacing water level probe.

7. Refill jacket with fluid. See FILLING THE

RESERVOIR JACKET.

8. Remove air from reservoir jacket as outlined

under VENTING.

Electric Stationary and Tilting Kettles - REMOVAL AND REPLACEMENT OF PARTS

Page 9 of 29 F45472 (1112)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 28 29

Comments to this Manuals

No comments

Vulcan K20EL User Manual Page 9

Comments to this Manuals

Related products and manuals for Kettles Vulcan K20EL