Vulcan K20GL User Manual download pdf (Page 12)

Fig. 16

9. Reverse procedure to install replacement burner

and check for proper operation.

Apply pipe thread sealant to burner

threads that is suitable for use with propane gas.

NOTE: Torque mounting nuts for combustion

chamber cover to 30 ft-lb.

SPARK IGNITOR

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Remove

CONTROL BOX COVER (TILTING) or

CORNER PANEL (STATIONARY).

2. Disconnect spark ignitor lead wires at ignition

module.

3. Remove BOTTOM COVER.

4. Remove clips holding insulation against

combustion chamber cover.

5. Remove spark ignitor from combustion chamber

cover.

Fig. 17

6. Ensure spark gap between ignitor electrode and

ground rod is approximately 1/8". If necessary,

adjust as outline under SPARK IGNITION TEST

Step 8C.

7. Reverse procedure to install and check for proper

operation.

Fig. 18

K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - REMOVAL AND REPLACEMENT OF PARTS

F45461 Rev. A (0713) Page 12 of 44

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

No comments

Vulcan K20GL User Manual Page 12