Vulcan K20GL User Manual download pdf (Page 15)

Fig. 24

DOWN LIMIT SWITCH (3S) - POWER

TILTING OPTION ONLY

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Place kettle in the fully upright position.

2. Remove CONTROL BOX COVER (TILTING).

3. Note lead wire locations and disconnect from

down limit switch (3S).

4. Remove adjustment screws (2) securring switch

bracket to mounting plate.

5. Remove mounting nuts and screws (2) securring

down limit switch (3S) to bracket.

6. Reverse procedure to install down limit switch

(3S).

7. Perform DOWN LIMIT SWITCH (3S)

ADJUSTMENT - POWER TILTING OPTION

ONLY.

Fig. 25

DC TILT MOTOR - POWER TILTING

OPTION ONLY

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Remove CONTROL BOX COVER (TILTING).

2. Remove motor cover from rear of control box.

Fig. 26

3. Disconnect DC tilt motor lead wires (2) at quick

disconnect terminals. The wires are labeled MTR

positive (+) and MTR negative (-).

4. Disconnect motor ground wire.

5. Remove motor mounting bolts and lock washers

from gear reducer flange.

K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - REMOVAL AND REPLACEMENT OF PARTS

Page 15 of 44 F45461 Rev. A (0713)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

No comments

Vulcan K20GL User Manual Page 15