Vulcan K20GL User Manual download pdf (Page 5)

CONTROL PANEL

Fig. 1

TOOLS

Standard

• Standard set of hand tools.

• Pipe thread sealant (must be resistant to the

action of propane gases).

• VOM with an AC current tester (meter sensitivity

should be at least 20,000 ohms per volt).

• Temperature meter (thermocouple type) for

checking kettle temperature.

• Manometer capable of reading at least 16" W.C.

of gas pressure.

• Container that is capable of holding at least 8

gallons of drained reservoir jacket fluid.

Special

• Torque wrench capable of tightening combustion

chamber mountings nuts to 30 ft-lbs.

• 36mm socket to remove sight glass for jacket

fluid draining.

• Requires U-inclined (Grainger P/N 3T294) or

digital (Grainger P/N 1XFW2) manometer for

measuring gas pressures and blower air

pressures.

• Dowfrost™ heat transfer fluid Part No. 558038 (5

gallon). Refer to FILLING THE RESERVOIR

JACKET for volumes.

• Distilled water only for re-filling of the jacket

(purchase locally). Refer to FILLING THE

RESERVOIR JACKET for volumes.

SPECIFICATIONS

Electric

• 120VAC / 60HZ / 1 phase

• 5 amp rating.

• Supplied with 6 foot power cord and 3-prong

grounding plug (proper ground required).

NOTE: Machines with electronic ignition systems

should be connected to a standard 120VAC electrical

outlet rather than a ground fault circuit interrupter

(GFCI) if possible. Machines connected to certain

GFCI circuits may repeatedly nuisance trip the GFCI.

If the machine must be connected to a GFCI, use Part

No. 913053 (Pass and Seymour) approved by

engineering for use with electronic ignition systems.

Gas Supply

NOTICE The gas supply pressure must not exceed

14” WC (½ PSI). Pressures higher than 14” WC will

damage the equipment’s gas controls and is not

covered under warranty. If the supply pressure

exceeds 14” WC an additional supply line regulator

rated for the supply line pressure (inches WC),

nominal pressure (OUT), and gas flow for the kettle

BTU rating must be installed.

Span gas technology enables "field adjustable

manifold pressure" from natural to propane gas or

propane to natural. All kettles shipped for natural gas

at sea level atmospheric pressure. Requires a U-

Inclined or digital manometer. See TOOLS.

Refer to F35461 Installation & Operation Manual for

specific instructions on GAS CONNECTIONS and

GAS AND ALTITUDE ADJUSTMENTS. A combustion

anaylizer is required for gas type conversions and

altitude adjustments as outlined in these procedures.

K Series Gas Kettles 2/3 Jacketed Stationary and Tilting - GENERAL

Page 5 of 44 F45461 Rev. A (0713)

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comments to this Manuals

No comments

Vulcan K20GL User Manual Page 5

Comments to this Manuals

Related products and manuals for Kettles Vulcan K20GL