Vulcan VG30 User Manual download pdf (Page 13)

GAS BRAISING PANS - REMOVAL AND REPLACEMENT OF PARTS

F25121 (February 2003)

Page 13 of 32

RIGHT SIDE REAR VIEW SHOWN

NOTE: Runner tube slides onto the gas orifice.

When installing, ensure runner tube is fully seated

onto gas orifice.

4. To remove gas orifice for inspection or

cleaning, disconnect the gas supply tube

compression fitting at the manifold.

5. Remove gas orifice from elbow fitting.

CAUTION: If orifice is clogged with debris, clean

with air or non-flammable liquid only.

6. Reverse procedure to install and check for

proper operation.

MAIN BURNERS

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

WARNING: SHUT OFF THE GAS SUPPLY

BEFORE SERVICING THE UNIT.

WARNING: ALL GAS JOINTS DISTURBED

DURING SERVICING MUST BE CHECKED FOR

LEAKS. CHECK WITH A SOAP AND WATER

SOLUTION (BUBBLES). DO NOT USE AN OPEN

FLAME.

1. Raise the pan to the full tilt position.

2. Remove the hold down wire from main burner.

3. Lift burner at rear to clear the locating pin hole

and slide burner toward the rear of burner box

pan to clear the orifice.

4. To remove gas orifice for inspection or

cleaning, remove the gas orifice from the elbow

fitting.

CAUTION: If orifice is clogged with debris, clean

with air or non-flammable liquid only.

5. Reverse procedure to install and adjust air

shutter as outlined under MAIN BURNERS.

NOTE: When installing, ensure locating pin is in the

hole for proper

positioning and hold down wire is re-

attached.

LID SPRINGS

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

1. Lower the lid to the full down position.

NOTE: For spring tension to be set correctly, both

the left and right side springs must be replaced.

2. Remove spring covers by prying up at the

bottom. The covers are held in place by tabs on

the bottom of cover.

3. Place a 1 5/8" wrench on the lid spring lock nut

and apply a downward force until locking pin

can be removed. Continue to hold lock nut in

place.

Caution: Do not release wrench while locking pin

is removed or damage to the braising pan may

occur.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Comments to this Manuals

No comments

Vulcan VG30 User Manual Page 13

Comments to this Manuals

Related products and manuals for Pressure cookers Vulcan VG30