Vulcan 24RRG User Manual download pdf (Page 6)

THERMOCOUPLE

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

Removal

1. Remove CONTROL PANEL.

2. Note thermocouple connections then disconnect

from temperature controller.

Fig. 4

3. Remove BACK PANEL.

4. From rear of griddle, loosen mounting nut and

remove probe from bottom of griddle plate.

Fig. 5

Installation

1. Apply a thin coating of heat transfer and anti-

seize compound to the probe tip and mounting

nut threads.

2. From rear of griddle, route thermocouple wires

and probe through the opening in heat shield.

3. Thread temperature probe into the mounting hole

in griddle plate and stop when probe tip touches

the plate. Torque the mounting nut to a maximum

of 25 in-lbs.

Do not over tighten or damage to the

thermocouple probe may occur. Due to the aluminum

plate core, It is also possible to create a raised area

over the probe if overtightened.

4. Check TEMPERATURE CONTROL

CALIBRATION.

TEMPERATURE CONTROLLER

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

1. Remove

CONTROL PANEL.

2. Note wire connections then disconnect them

from temperature controller.

RRG SERIES HEAVY DUTY GAS GRIDDLE - REMOVAL AND REPLACEMENT OF PARTS

F45514 (0214) Page 6 of 24

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Vulcan 24RRG User Manual Page 6

Comments to this Manuals

Related products and manuals for Grills Vulcan 24RRG