Vulcan 24RRG User Manual download pdf (Page 7)

Fig. 6

3. Remove knob from temperature control shaft.

4. Note temperature control orientation as mounted

to control panel. Remove mounting nut from

temperature control shaft and remove control

from panel.

Fig. 7

5. Reverse procedure to install.

6. Check TEMPERATURE CONTROL

CALIBRATION.

BURNER

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

1. Remove BACK PANEL.

2. Remove the nut that is securing burner.

Fig. 8

3. Lift back of burner until locating pin clears hole

and pull out burner.

4. Reverse proceedure to install.

PILOT BURNER

Disconnect the

electrical power to the machine and

follow lockout / tagout procedures.

Shut off the gas before servicing the

unit.

All gas joints disturbed during

servicing must be checked for leaks. Check with a

soap and water solution (bubbles). Do not use an open

flame.

1. Remove GAS PRESSURE REGULATOR.

RRG SERIES HEAVY DUTY GAS GRIDDLE - REMOVAL AND REPLACEMENT OF PARTS

Page 7 of 24 F45514 (0214)

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Vulcan 24RRG User Manual Page 7